PM16DO - 16 DIGITAL OUTPUT MODULE

This module has 16 open collector (NPN) digital outputs. The outputs may be used to drive lamps or external relays when more drive capability is required. The outputs are isolated from the logic and they share a common negative terminal.

Each output can be individually switched on or off, or all outputs can be set up at the same time by writing a single number to the output register which represents the status of all outputs.

The module may be used as either a slave or master on the Modbus network. When used with a PC or PLC the module will be configured as a slave. When used with a PM16DI module in a point-to-point configuration, the DIP switch 9 must be turned on to set the module up as a master. In this mode the PM16DO module will automatically read the information from the PM16DI module and write the input status to the outputs.

An output watchdog timer can be configured to switch off all the outputs if there has been no communications with the module for up to 255 seconds. A value of 0 seconds will disable this timer and the outputs will remain in the last programmed state.

PM16DO - 16 DIGITAL OUTPUT MODULE

Digital Outputs

16

Type

NPN Open collector

Max Load Current

100mA per channel

Max load Voltage

36Vdc

Vce (on) Voltage

1.1V (max)

Watch dog output timer

Disable or 1-255 sec adjustable

Isolation (Field & Logic)

1500VAC RMS

Status Indication

LED for each channel

Power supply (Field)

+12Vdc to +24Vdc

Order Codes

  • PM16DO - 16 DIGITAL OUTPUT MODULE

Want more information?

Fill in your details below to receive more information on the:

PM16DO - 16 DIGITAL OUTPUT MODULE

  • Country
  • This field is for validation purposes and should be left unchanged.
Procon Electronics