PC6RO - 6 Relay Output Module

The PC6RO module has 6 normally open/ normally closed relay outputs. These modules may be used when a higher drive capability is required, or when isolation between outputs are required.

The module plugs into a special bus connector which fits inside the DIN rail. The power supply voltage and the CAN bus signals are connected via this bus connector.

The CAN interface is electrically isolated and is compliant with ISO 11898.

The module has been equipped with status led’s which are used to indicate the status of the Inputs and communications. This visual indication assists with fault finding and diagnostics.

The CANopen node ID and bit rate can be setup by DIP switches or software.

Power Supply

Logic Supply Voltage

24 Vdc

Logic Supply Current


Relay Outputs

Output Points


Maximum Current

1A @ 220VAC / 1A @ 28VDC


4000Vrms between field and logic
1500Vrms between outputs



Error Control

Node Guarding / Consumer Heartbeat

Node ID

DIP switch or software

CANopen Data

Number of PDO

1 Rx

PDO Modes

Event Controlled Asynchronous,
Event Timer Asynchronous,
Sync – Acyclic, Sync – Cyclic.

PDO Mapping


PDO Linking


Number of SDO

1 Server

Error Message



Operating Temperature.

-20°C to + 70°C

Storage Temperature

-40°C to + 85°C


Logic Power and Comms.

5 way connector that clips onto DIN rail


6 x 3 Way screw connector on top and bottom

Order Codes

  • PC6RO - 6 Relay Output Module

Want more information?

Fill in your details below to receive more information on the:

PC6RO - 6 Relay Output Module

  • Country
  • This field is for validation purposes and should be left unchanged.
Procon Electronics