|
8 ANALOG INPUTS
The Analog Input modules are supplied as either a current input module (MM8AI/I) or a voltage input module (MM8AI/V). The inputs are isolated from the logic and share a common negative terminal. The standard setting for the MM8AI/I module is 0 - 20mA input current which represents an output value of 0 - 4095 (12 bits) in the corresponding Modbus register. To obtain an output value of 0 to 4095 for an input signal of 4 to 20mA the offset switch is switched on. The same applies to the MM8AI/V module. An input voltage of 0 - 10Volts represents an output of 0 - 4095 and 2 volts would give a reading of 819 ± 1LSB. To obtain an output value of 0 to 4095 for an input signal of 2 to 10V the offset switch is switched on. An input range of 0(1) to 5Vdc is available by removing the jumper link located on the analogue board inside the enclosure.
Power Supply: Logic 10 - 26 Vdc @ 50 mA Field 10 - 26 Vdc @ 25 mA Inputs: Voltage 0(2) - 10 Vdc or 0(1) - 5 Vdc - 8AI/V Current 0(4) - 20 mA - 8AI/I Input Resistance (8AI/V) 20kohms Input Resistance (8AI/I) 250ohms Resolution 12 bits Isolation 1500Vrms between field and logic Drift 100ppm/°C Accuracy 0.2% of span Connector: 11 Pin Connector on rear of unit 10 Way screw connector on front
|
|
Send mail to proconel@proconel.com with
questions or comments about this web site.
|
