|
|
The RS232 Fibre Optic converter is
ideal for extending RS232 signals through areas of high electrical noise due to
the EMI immunity of fibre. Standard features of the
converter are : · Multiple Fibre Sizes. Three
fibre sizes are supported as standard on the converter module. · Industry Standard Fibre connectors. The
converter can be ordered for use with either the industry standard SMA or ST™
style connectors. · DIN Rail Mount.
The converter module plugs directly into a 11PIN industry standard relay
base which may be DIN rail mounted or flush mounted.
POWER REQUIREMENT: 200 - 260VAC 50/60Hz. – LED POWER indication PORT TX/RX INDICATORS: 1 x TX led and 1 x RX led per port. FIBRE CONNECTORS : Supplied with either SMA or ST connectors. FIBRE SIZES: 50/125mm, 62.5/125mm, and 100/140mm. TRANSMITTER WAVELENGTH: 820 Nanometre. Multi-Mode. TRANSMISSION DISTANCE: Up to 2 Km depending on attenuation of fibre used. BAUD RATE: Selectable per port – 1200, 2400, 4800, 9600, 19200 and 38400. DATA BITS: Selectable per port - 7 or 8 data bits STOP BITS: Selectable per port – 1 or 2 stop bits PARITY BITS: Selectable per port - none, even or odd parity ISOLATION: Transformer/OptoCoupler - 1500VACrms OPERATING TEMPERATURE: -20°C to + 80°C. DIMENSIONS: 105mm (HIGH) X 70mm (WIDE) X 60mm (DEEP) ST™ is a registered trademark of AT&T Lightguide Cable Connectors.
SWITCH SW1 - RS232 PORT 1 SETUP SWITCH SW2
- FIBRE
PORT 2 SETUP
Order
Code
Description MM232FIBRE RS232 FIBRE OPTIC CONVERTER
|
|
Send mail to proconel@proconel.com with
questions or comments about this web site.
|
The
MOD-MUX RS232 / Fibre Optic converter module is used to convert RS232 data
communications signals for transmission over fibre optic cables. The converters
can be used to extend the limited distance capabilities of RS232 devices such as
printers and terminals for up to two kilometres. 
